Q. Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

View solution

Q. If an analog voltage is expressed in binary using 4 bits, each successive binary count would represent

View solution

Q. In a 4 input AND gate, the total number of High outputs for 16 input states are

View solution

Q. Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using

View solution

Q. The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be

View solution

Q. In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require

View solution

Q. A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,

View solution

Q. A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are

View solution

Q. Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

View solution

Q. Hexadecimal number F is called to octal number

View solution

Q. A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are

View solution

Q. TTL logic is preferred to DRL logic because

View solution

Q. Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits

Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.

View solution

Q. A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is

View solution

Q. What do the contents of instruction register specify?

View solution

Q. In the decimal number 27, the digital 2 represents

View solution

Q. Which of the following is true?

View solution

Q. E7F6₁₆ = __________ .

View solution

Q. What is the normal range of analog input voltage?

View solution

Q. Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

View solution