Q. The most suitable method for detecting a modulated signal g(t) = (3 to 6 cos 2πfmt) cos 2πfct is

View solution

Q. A total of 16 equally probable events exist. If it is required to select one out of them, the number of required bits is

View solution

Q. When modulation index of an AM wave is increased from 0.5 to 1, the transmitted power

View solution

Q. Quantizing error occurs in

View solution

Q. In audio cassettes the width of each recording track is

View solution

Q. The most commonly used transistor amplifier circuit is

View solution

Q. When energy is fed into open wire transmission line the energy may get dissipated due to

View solution

Q. Loudness control gives

View solution

Q. A mobile telephone has a range of about

View solution

Q. If transmitted power is 75 kW, the field strength at 30 km distance will be about

View solution

Q. The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about

View solution

Q. When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be

View solution

Q. A message signal with bandwidth 10 kHz is lower sideband SSB modulated with carrier frequency fc1 = 10⁶ Hz. The resulting signal is then passed though a narrow band frequency modulator with carrier frequency fc2 = 10⁹ Hz. The bandwidth of the output would be

View solution

Q. In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor.

View solution

Q. For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will

View solution

Q. The video heads, in VCR, feed the other circuit

View solution

Q. A high pulse repetition frequency in a radar

View solution

Q. In PCM, the biggest disadvantage as compared to AM is

View solution

Q. Which of the following microphones is the cheapest?

View solution

Q. If a line is terminated in characteristic impedance Z₀, the input impedance measured at the input will be

View solution