Q. Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is

View solution

Q. In Vidicon camera tube, the resistance of photoconductive material on the target plate

View solution

Q. Which of the following are useful in comparing the noise performance of receivers?

1. Input noise voltage
2. Noise figure
3. Noise resistance
4. Noise temperature

Select answer as per the following codes:

View solution

Q. Push pull amplifier is

View solution

Q. The tape recorders used in homes have

View solution

Q. In a communication system, noise is most likely to affect the signal

View solution

Q. Each frequency in the modulating wave gives rise to four side bands.

View solution

Q. Assertion (A): CCIR-B system has 625 scanning lines per frame and 2 : 1 interlace.

Reason (R): The aspect ratio is 4 : 3

View solution

Q. At night the ionosphere can be considered to be consisting of

View solution

Q. A balun transformer gives an impedance transformation of

View solution

Q. Which one of the following is true?

View solution

Q. A 1000 kHz carrier wave modulated 40% at 40000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulator after transmission through the circuit?

View solution

Q. The EHT voltage in a picture tube of TV is

View solution

Q. Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

View solution

Q. An S/N ratio of 3 expressed in db is

View solution

Q. The material used for the magnet of moving coil cone type loudspeaker is

View solution

Q. CCIR system B employs

View solution

Q. The power to the base unit of a cordless telephone is supplied by

View solution

Q. In cellular telephone each cell is designed to handle

View solution

Q. A UPS contains

View solution