Question

A 1000 kHz carrier wave modulated 40% at 40000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulator after transmission through the circuit?

a.

40%

b.

20%

c.

0.27

d.

0.54

Answer: (c).0.27

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A 1000 kHz carrier wave modulated 40% at 40000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulator after...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The EHT voltage in a picture tube of TV is

Q. Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Q. An S/N ratio of 3 expressed in db is

Q. The material used for the magnet of moving coil cone type loudspeaker is

Q. CCIR system B employs

Q. The power to the base unit of a cordless telephone is supplied by

Q. In cellular telephone each cell is designed to handle

Q. A UPS contains

Q. A transmitter power of 10 W is increased by 30 dB. The effective radiated power is

Q. It is desired to couple a coaxial line to a two parallel wire line. It is best to use

Q. 24 telephone channels are frequency division multiplexed using an SSB modulation. Assuming 3 kHz per channel, the required band width is

Q. If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about

Q. A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is

Q. In FM, as bandwidth increases

Q. A 400 W carrier is amplitude modulated with m = 0.75. If single side band suppressed carrier is used the total power in modulated wave is

Q. In TV transmitter, the function of duplexer is

Q. The PSD and the power of a signal g(t) are respectively Sg(ω) and Pg, the PSD and the power of signal a.g(t) are respectively

Q. The simplest method of suppression of unwanted side band in AM is

Q. For attenuation of low frequencies we should use

Q. Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.

Reason (R): Devices using SAW principle are used in many systems.

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!