Question
Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R are correct but R is not correct explanation of A
c.
A is correct but R is wrong
d.
A is wrong but R is correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): Inter-digitated geometry is widely used for microwave transistors. Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
View solution
Q. Hollow waveguides are used as transmission lines at frequencies
View solution
Q. To ensure that only dominant TE₁₀ mode propagates in a rectangular waveguide, the operating frequency
View solution
Q. In a microwave power measurement using bolometer, the principle of working is variation of
View solution
Q. Z₀ = (Zoc Zsc)^0.5
View solution
Q. A microwave junction is matched at all ports if the S matrix
View solution
Q. Assertion (A): A line of length slightly more than λ/4 and open circuited at far end is equivalent to an inductive reactance.
Reason (R): A line of length slightly more than λ/4 and short circuited at far end behaves as a capacitive reactance.
View solution
Q. The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
View solution
Q. The AM, PM, and TV broadcast frequencies are
View solution
Q. Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.
Reason (R): In a symmetrical matrix Sij = Sji.
View solution
Q. In TE mode of waveguide Ez = 0
View solution
Q. The primary constants of a transmission line are
View solution
Q. As compared to their values in free space
View solution
Q. Characteristic impedance of a coaxial cable is inversely proportional to √∈r.
View solution
Q. A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by
View solution
Q. Depth of penetration does not depend on frequency.
View solution
Q. TE₀₁ mode of propagation of electromagnetic energy
View solution
Q. Assertion (A): Slotted line is frequently used for microwave measurements.Reason (R): The unknown impedance is mounted at the end of slotted line.
View solution
Q. Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
View solution
Q. The following components are used to measure power output of a 2 kW TWT amplifier
1. TWT
2. Low pass/High pass filter
3. Low power 20 dB attenuator
4. 40 dB directional coupler with matched load
5. Power meter
The correct sequence of connections of these components is:
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
