Question
a.
sphere
b.
rectangle
c.
square
d.
ellipse
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The AM, PM, and TV broadcast frequencies are
View solution
Q. Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.
Reason (R): In a symmetrical matrix Sij = Sji.
View solution
Q. In TE mode of waveguide Ez = 0
View solution
Q. The primary constants of a transmission line are
View solution
Q. As compared to their values in free space
View solution
Q. Characteristic impedance of a coaxial cable is inversely proportional to √∈r.
View solution
Q. A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by
View solution
Q. Depth of penetration does not depend on frequency.
View solution
Q. TE₀₁ mode of propagation of electromagnetic energy
View solution
Q. Assertion (A): Slotted line is frequently used for microwave measurements.Reason (R): The unknown impedance is mounted at the end of slotted line.
View solution
Q. Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
View solution
Q. The following components are used to measure power output of a 2 kW TWT amplifier
1. TWT
2. Low pass/High pass filter
3. Low power 20 dB attenuator
4. 40 dB directional coupler with matched load
5. Power meter
The correct sequence of connections of these components is:
View solution
Q. Which part of radio spectrum is more crowded?
View solution
Q. The most commonly used magnetron is
View solution
Q. The effect of earth's magnetic field on radiowaves is minimum when
View solution
Q. A line of characteristic impedance Z₀ branches into two line each with characteristic impedance Z₀. The refracted voltage is
View solution
Q. The resistance values of a PIN diode under positive bias and negative bias respectively are about
View solution
Q. A PIN diode can be used
View solution
Q. What is the numerical aperture an optical fiber when critical angle is 30°?
View solution
Q. A line of length slightly less than λ/4 and short circuited at far end behaves as
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
