Question

The following components are used to measure power output of a 2 kW TWT amplifier

1. TWT
2. Low pass/High pass filter
3. Low power 20 dB attenuator
4. 40 dB directional coupler with matched load
5. Power meter

The correct sequence of connections of these components is:

a.

1, 4, 2, 3, 5

b.

1, 3, 4, 2, 5

c.

1, 2, 4, 3, 5

d.

1, 4, 3, 2, 5

Answer: (b).1, 3, 4, 2, 5

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The following components are used to measure power output of a 2 kW TWT amplifier 1. TWT 2. Low pass/High pass filter 3. Low power 20 dB attenuator 4. 40 dB directional...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which part of radio spectrum is more crowded?

Q. The most commonly used magnetron is

Q. The effect of earth's magnetic field on radiowaves is minimum when

Q. A line of characteristic impedance Z₀ branches into two line each with characteristic impedance Z₀. The refracted voltage is

Q. The resistance values of a PIN diode under positive bias and negative bias respectively are about

Q. A PIN diode can be used

Q. What is the numerical aperture an optical fiber when critical angle is 30°?

Q. A line of length slightly less than λ/4 and short circuited at far end behaves as

Q. In TE₁₀ mode of rectangular waveguide

Q. Reflection from the object to be measured is significant only when the wavelength is

Q. The speed at which axial electric field due to signal advances in a TWT is equal to

Q. Slotted line can be used for measurement of high frequencies

Q. In a waveguide the dielectric region is generally

Q. A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is

Q. A line of length slightly longer than λ/4 and open circuited at far end behaves as

Q. Klystron amplifier is not used to amplifier very weak microwave signals due to

Q. Which of the following modes in circular waveguides are circularly symmetric?

Q. Which of the following lines behaves as infinite line?

Q. A rectangular waveguide has two stubs each length λ/4 connected at the source end. The stubs are short circuted. Then

Q. Performance of a PIN diode switch is represented by

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!