Question
a.
a shunt capacitance at the discontinuity
b.
a shunt inductance at the discontinuity
c.
a shunt resistance at the discontinuity
d.
none of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Depth of penetration does not depend on frequency.
View solution
Q. TE₀₁ mode of propagation of electromagnetic energy
View solution
Q. Assertion (A): Slotted line is frequently used for microwave measurements.Reason (R): The unknown impedance is mounted at the end of slotted line.
View solution
Q. Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
View solution
Q. The following components are used to measure power output of a 2 kW TWT amplifier
1. TWT
2. Low pass/High pass filter
3. Low power 20 dB attenuator
4. 40 dB directional coupler with matched load
5. Power meter
The correct sequence of connections of these components is:
View solution
Q. Which part of radio spectrum is more crowded?
View solution
Q. The most commonly used magnetron is
View solution
Q. The effect of earth's magnetic field on radiowaves is minimum when
View solution
Q. A line of characteristic impedance Z₀ branches into two line each with characteristic impedance Z₀. The refracted voltage is
View solution
Q. The resistance values of a PIN diode under positive bias and negative bias respectively are about
View solution
Q. A PIN diode can be used
View solution
Q. What is the numerical aperture an optical fiber when critical angle is 30°?
View solution
Q. A line of length slightly less than λ/4 and short circuited at far end behaves as
View solution
Q. In TE₁₀ mode of rectangular waveguide
View solution
Q. Reflection from the object to be measured is significant only when the wavelength is
View solution
Q. The speed at which axial electric field due to signal advances in a TWT is equal to
View solution
Q. Slotted line can be used for measurement of high frequencies
View solution
Q. In a waveguide the dielectric region is generally
View solution
Q. A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is
View solution
Q. A line of length slightly longer than λ/4 and open circuited at far end behaves as
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
