Q. Evaporator tubes are generally

View solution

Q. In a boiling curve, the peak heat flux is called the __________ point.

View solution

Q. Pick out the wrong statement.

View solution

Q. The type of liquor circulation system to be employed in evaporators (viz. natural or forced circulation) is determined mainly by the __________ of the liquid.

View solution

Q. Thermal diffusivity is the most important in heat transfer by

View solution

Q. (NGr x NPr) is called the __________ number.

View solution

Q. A dephlegmator is a

View solution

Q. Rate of crystallisation does not depend upon the

View solution

Q. Stefen's block body radiation law can also be derived from __________ law.

View solution

Q. Multipass heat exchangers are used

View solution

Q. A hollow sphere and a solid sphere of the same material and equal radii are heated to the same temperature. In this case,

View solution

Q. Condensing film co-efficient for steam on horizontal tubes ranges from 5000 to 15000 Kcal/hr.m² .°C. Condensation of vapor is carried out inside the tube in a shell and tube heat exchanger, when the

View solution

Q. Viscosity of gases __________ with increase in temperature.

View solution

Q. What is the emissivity of a black body ?

View solution

Q. Steam is routed through the tube in case of a __________ evaporator.

View solution

Q. Dropwise condensation of steam on cooling surface is promoted

View solution

Q. Conduction occurs in the buffer zone for a fluid flowing through a heated pipe, only when Prandtl number is

View solution

Q. The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as

View solution

Q. Maximum heat transfer rate is achieved in __________ flow.

View solution

Q. Wavelength corresponding to the maximum energy is inversely proportional to the absolute temperature. This is __________ law.

View solution