Q. Pick out the wrong statement pertaining to the comparative evaluation of performance of the packed tower and the plate tower.

View solution

Q. The circumferential (hoop) stress in a thin walled cylinderical vessel under internal pressure is

View solution

Q. Lₑ/D for fully open gate valves would be

View solution

Q. LMTD correction factor is used in heat exchanger design for

View solution

Q. Pick out the wrong statement about the design of a sieve plate column.

View solution

Q. Generally, no corrosion allowance in wall thickness of a part is required, if the thickness is more than __________ mm.

View solution

Q. Multiple blade paddle agitator is used for mixing high viscosity liquids/paste in which the paddle diameter is commonly 0.8 times the tank diameter. However, the width of the blade is in the range of __________ times the paddle diameter.

View solution

Q. In a __________ rivetted joint, the rivets in the various rows are opposite to each other.

View solution

Q. Pick out the wrong statement:

View solution

Q. Speed of industrial paddle agitator ranges from __________ rpm.

View solution

Q. __________ strain is measured using a 'strain rosetter'.

View solution

Q. Thin spherical shells subjected to internal pressure, develop __________ stresses.

View solution

Q. With increase in the reflux ratio for a fixed production from a continuous binary distillation column, the __________ decreases.

View solution

Q. The slope of operating line in the rectifying section of a distillation column is unity, if the reflux ratio is

View solution

Q. Thickness of the frame of a plate and frame filter as compared to that of plates is

View solution

Q. Which of the following factors affect the pressure drop in a co-current gas-liquid absorption packed tower ?

View solution

Q. The thickness of heat transfer plates used in the plate type heat exchanger ranges from __________ mm, pressed in a single piece provided with grooves & corrugations.

View solution

Q. Rivets are generally specified by the

View solution

Q. Length to diameter ratio of most rotary driers is in the range of

View solution

Q. Vertical vessels are not supported by

View solution