Question
a.
positive
b.
negative
c.
no
d.
none of these
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A binary liquid azeotropic mixture has boiling point lower than either of the components, when it shows __________ deviation from Raoult's Law.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In which of the following evaporators, steam is fed inside the tube while the liquor is outside the tube ?
View solution
Q. A high vapour velocity is required for high plate efficiency in a seive plate coloumn. The satisfactory value of operating vapor velocity for design purpose in seive plate column is about __________ percent of the flooding velocity.
View solution
Q. The approximate liquid depth in an agitation tank is equal to (where, d = tank diameter)
View solution
Q. Baffle width is normally taken as __________ times the tank diameter.
View solution
Q. A cylinderical pressure vessel of volume 6 πm³ has to be designed to withstand a maximum internal pressure of 10 atm. The allowable design stress of the material is 125N/mm² and corrosion allowance is 2 mm. The thickness of the vessel for a length/diameter ratio of 3 will be close to
View solution
Q. Which of the following packing materials provides for maximum mass transfer ?
View solution
Q. Cylindrical storage tanks used for the storage of volatile liquids (e.g., naphtha) have __________ roofs.
View solution
Q. Larger depth of liquid on the trays of a distillation column
View solution
Q. Pick out the wrong statement.
View solution
Q. Pick out the wrong statement.
View solution
Q. In the downcomer of a distillation column, the minimum recommended residence time is about __________ seconds.
View solution
Q. In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for
View solution
Q. For turbine agitator, the impeller diameter is about
View solution
Q. If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will __________ times.
View solution
Q. __________ of water makes it a widely used coolant in heat exchangers.
View solution
Q. The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)
View solution
Q. Fouling factor must be included in the calculation of over all design heat transfer coefficient, when the liquid
View solution
Q. Lug support is meant for supporting __________ vessels.
View solution
Q. Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.
View solution
Q. Most of the storage vessels/tanks are made cylindrical, because of the fact that a cylinder
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!