Q. A cylinderical pressure vessel of volume 6 πm³ has to be designed to withstand a maximum internal pressure of 10 atm. The allowable design stress of the material is 125N/mm² and corrosion allowance is 2 mm. The thickness of the vessel for a length/diameter ratio of 3 will be close to

View solution

Q. Which of the following packing materials provides for maximum mass transfer ?

View solution

Q. Cylindrical storage tanks used for the storage of volatile liquids (e.g., naphtha) have __________ roofs.

View solution

Q. Larger depth of liquid on the trays of a distillation column

View solution

Q. Pick out the wrong statement.

View solution

Q. Pick out the wrong statement.

View solution

Q. In the downcomer of a distillation column, the minimum recommended residence time is about __________ seconds.

View solution

Q. In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for

View solution

Q. For turbine agitator, the impeller diameter is about

View solution

Q. If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will __________ times.

View solution

Q. __________ of water makes it a widely used coolant in heat exchangers.

View solution

Q. The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)

View solution

Q. Fouling factor must be included in the calculation of over all design heat transfer coefficient, when the liquid

View solution

Q. Lug support is meant for supporting __________ vessels.

View solution

Q. Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.

View solution

Q. Most of the storage vessels/tanks are made cylindrical, because of the fact that a cylinder

View solution

Q. The distance between the top of the slots and the liquid surface when the static liquid is just ready to flow over the overflow weir is called

View solution

Q. Liquid gradient over the tray results due to the

View solution

Q. The centre to centre distance between two consecutive baffles in a shell and tube heat exchanger is called the baffle pitch or baffle spacing, which is more than 1/5th the I.D. of the shell. Which of the following is not a function of the baffles ?

View solution

Q. Bubble cap plate column is

View solution