Question
a.
0.01 L.S
b.
0.087 L.S
c.
L.S
d.
L.S/0.087
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater width of the discharge opening, cm)
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Vacuum is applied in __________ zone, in case of a general type continuous rotary drum vacuum filter.
View solution
Q. Which of the follwoing mechanical conveyors does not come under the division 'scrapers' ?
View solution
Q. Length/diameter ratio of a ball mill is
View solution
Q. Feed size of ≥ 25 cms can be accepted by
View solution
Q. Which is the most suitable conveyor for transportation of sticky material ?
View solution
Q. The most suitable equipment for removing the fine dust particle (< 1 micron dia.) from air below its dew point will be a/an
View solution
Q. Laminar flow region is said to exist during agitation of a liquid in an agitator, when the value of Reynolds number is
View solution
Q. Basic slag is not ground in
View solution
Q. Grindability of a material does not depend upon its
View solution
Q. Shape factor for a cylinder whose length equals its diameter is
View solution
Q. In case of a hammer crusher, the
View solution
Q. Dust laden air can be purified using a
View solution
Q. Energy consumed for crushing one ton of material ranges from __________ kWh.
View solution
Q. For transporting pasty material, one will use a/an
View solution
Q. Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a
View solution
Q. A tube mill compared to a ball mill
View solution
Q. Trommels separate a mixture of particles depending on their
View solution
Q. Size reduction does not occur due to compression in case of
View solution
Q. According to Taggart's rule for selecting between a gyratory crusher and a jaw crusher; the later should be used, if the hourly tonnage to be crushed divided by the square of the gape expressed in cm is less than
View solution
Q. Which of the following represents the plot of filtrate volume versus time for constant pressure filtration ?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!