Q. General mechanism of size reduction in intermediate and fine grinder is by

View solution

Q. A straight line is obtained on plotting reciprocal of filtration rate vs. the volume of filtrate for __________ flow of filtrate.

View solution

Q. The work index in Bond's law for crushing of solids has the following dimensions

View solution

Q. In bag filters, filter fabrics are never made of

View solution

Q. Use of 'grinding aids' is done in __________ grinding.

View solution

Q. Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)

View solution

Q. Which of the following is the most suitable filter for separation of abrasive solids suspended in a corrosive liquid ?

View solution

Q. All resistances during washing of cake

View solution

Q. Ore concentration by jigging is based on the difference in the __________ of the particles.

View solution

Q. Size measurement of ultrafine particles can be best expressed in terms of

View solution

Q. Reduction ratio of crushers is the

View solution

Q. Which is a secondary crusher for a hard & tough stone ?

View solution

Q. Cyclones are used primarily for separating

View solution

Q. There is practically no alternative/competitor to __________ in the beneficiation treatment of sulphide ores.

View solution

Q. Separation of isotopes is generally done using a/an __________ centrifuge.

View solution

Q. Temperature of the product during ultrafine grinding

View solution

Q. Reciprocating screens are normally inclined at an angle of 5° with the horizontal and employ gyratory motion at feed end & reciprocating motion at the discharge end. They are not suitable for the screening of the

View solution

Q. Width and speed of a conveyor belt depends upon the __________ of the material.

View solution

Q. Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for

View solution

Q. Pick out the wrong statement.

View solution