Question
a.
212.2 m
b.
212.6 m
c.
211.8 m
d.
It cannot be predicted
Posted under Irrigation Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A siphon aqueduct is constructed at a canal crossing site where drainage HFL was 212.2 m by allowing an afflux of 0.4 m at high flood discharge. At this site, the water level...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Calculate the depth of cut-off for scour holes for an irrigation channel of F.S.Q equal to 354 cumecs and H.F.Q of natural drainage equal to 600 cumecs. Assume the value of friction factor as 1.
View solution
Q. Calculate the value of hydraulic mean radius for a channel designed by Lacey’s theory which has a mean velocity of 1m/sec. The silt factor can be taken as unity.
View solution
Q. Which of the following is usually adopted for contraction and construction joints?
View solution
Q. Which of the following is not a movement joint?
View solution
Q. A partial contraction joint is the one in which?
View solution
Q. Which of the following is a movement joint with deliberate discontinuity but no initial gap?
View solution
Q. Which of the following is a movement joint with complete discontinuity in both reinforcement and concrete and intended to accommodate either expansion or contraction of the structure?
View solution
Q. In reinforced concrete floors, the movement joints should normally be spaced at a maximum spacing of ____________
View solution
Q. The expansion joints in floors and walls should normally be provided at a spacing of not more than ___________
View solution
Q. What is the maximum expansion or contraction allowed for the joint filler material with an initial gap of about 30 mm?
View solution
Q. Which of the following can be used as support for an effective joint sealing compound in floor and floor joints?
View solution
Q. What provides a permanent watertight seal during the whole range of joint movement?
View solution
Q. Which of the following is sometimes used in expansion joints to avoid the risk of fault in an embedded water bar?
View solution
Q. Joint sealing compounds are impermeable ductile materials which are required to ___________________
View solution
Q. In case of the sealing joint, the lower part of the joint is occupied by joint filler.
View solution
Q. What is the most common metal used for water stops?
View solution
Q. The use of sealing compounds for vertical joints is very successful.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Irrigation Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
