Q. A uniform, slender cylindrical rod is made of a homogeneous and isotropic material. The rod rests on a frictionless surface. The rod is heated uniformly. If the radial and longitudinal thermal stress are represented by σx and σz, then ___________

View solution

Q. Which one of the following are true for the thermal expansion coefficient?

View solution

Q. The length, coefficient of thermal expansion and Youngs modulus of bar A are twice of bar B. If the temperature of both bars is increased by the same amount while preventing any expansion, then the ratio of stress developed in bar A to that in bar B will be ___________

View solution

Q. Which test is conducted to measure the ability of a material to resist scratching, abrasion, deformation and indentation?

View solution

Q. Which test is conducted to measure the endurance limit of the material?

View solution

Q. What is the process in which the metal is cooled rapidly in water after heating the metal above the lower critical temperature to increase the hardness of the material?

View solution

Q. What is the process of heating the metal in the furnance to a temperature slightly above the upper critical temperature and cooling slowly In the furnance.

View solution

Q. Photo stress method is ___________

View solution

Q. What is the factor of safety?

View solution

Q. Which one of the following has the largest value of thermal coefficient?

View solution

Q. Identify which factor may cause a lowered body temperature:

View solution

Q. If a bar of two different length are in a line and P load is acting axially on them then what will be the change in length of the bar if the radius of both different lengths is same?

View solution

Q. If a bar of two sections of different diameters of same length are in a line and P load is acting axially on them then what will be the change in length of the bar?

View solution

Q. Does the value of stress in each section of a composite bar is constant or not?

View solution

Q. A composite bar of two sections of equal length and equal diameter is under an axial pull of 10kN. What will be the stresses in the two sections?

View solution

Q. A composite bar of two sections of unequal length and equal diameter is under an axial pull of 10kN. What will be the stresses in the two sections?

View solution

Q. A composite bar of two sections of equal length and given diameter is under an axial pull of 15kN. What will be the stresses in the two sections in N/mm²?

View solution

Q. Which law states the when a number of loads are acting on a body, the resulting strain, according to principle of superposition, will be the algebraic sum of strains caused by individual loads?

View solution

Q. How the total strain in any body subjected to different loads at different sections can be calculated?

View solution

Q. Three sections in a beam are of equal length of 100mm. All three sections are pulled axially with 50kN and due to it elongated by 0.2mm. What will be the resultant strain in the beam?

View solution