Q. Vₚ is leading in phase, while Vₛ is lagging in phase.

View solution

Q. What is the effect of p.f. on secondary burden?

View solution

Q. How is the transformation ratio dependent on the secondary burden?

View solution

Q. Decrease in p.f. makes Vₛ to lead Vₚ.

View solution

Q. At constant voltage how is frequency affected by flux?

View solution

Q. A 50 Hz, bar primary CT has a secondary with 800 turns. The secondary supplies 7 A current into a purely resistive burden of 2 Ω. The magnetizing ampere-turns are 300. The phase angle is?

View solution

Q. A 50 Hz, bar primary CT has a secondary with 500 turns. The secondary supplies 5 A current into a purely resistive burden of 1 Ω. The magnetizing ampere-turns are 200. What is the ratio error at full load, if the iron loss is 1.5 W and magnetizing mmf is 100 A?

View solution

Q. A 1000/5 A, 50 Hz correct transformer has a secondary burden comprising a non-inductance of 1.6Ω. The flux in the core at full load is?

View solution

Q. A 1000/5 A, 50 Hz correct transformer has a secondary burden comprising a non-inductance of 2Ω. What is the ratio error, if the iron loss is 3 W and magnetizing mmf is 250 A?

View solution

Q. A 200/1 Current Transformer (CT) is wound with 400 turns on the secondary on a toroidal core. When it carries a current of 180 A on the primary, the ratio is found to be -0.5%. If the number of secondary turns is reduced by 1, the new ratio error (in %) will be?

View solution

Q. A (350 A/ 7A), 50 Hz current transformer has a primary bar. The secondary burden is a pure resistance of 1 Ω and it draws a current of 5 A. The magnetic core requires 350 AT for magnetization. Find the percentage ratio error.

View solution

Q. The observation when the secondary winding of a current transformer is open-circuited is?

View solution

Q. Usually a CT has ____________

View solution

Q. A PT is a device which is ___________

View solution

Q. The CT supplies current to the current coil of a wattmeter power factor meter, energy meter and, an ammeter. These are connected as?

View solution

Q. In a moving iron meter, the deflection torque is proportional to?

View solution

Q. The full-scale deflection current of an ammeter is 4 mA and its internal resistance is 400Ω. If this meter is to have a full deflection of 10 A, what is the value of the shunt resistance to be used?

View solution

Q. The full-scale deflection current of a meter is 4 mA and its internal resistance is 400Ω. This meter is to have full deflection when 400 V is measured. What is the value of the series resistor to be used?

View solution

Q. Two ammeters, one with a full-scale current of 1 mA and internal resistance of 100 Ω and other a full-scale current of 10 mA and internal resistance of 25 Ω are in parallel. What is the total current, these two meters can carry without the reading out of scale in any meter?

View solution

Q. A meter has a full scale of 90° at a current of 1 A. This meter has a perfect square law response. What is the current when the deflection angle is 45°?

View solution