Q. The coefficient of curvature for a well graded soil, must be between

View solution

Q. A moist soil sample weighing 108 g has a volume of 60 cc. If water content is 25% and value of G = 2.52, the void ratio is

View solution

Q. The shear resistance of a soil is con-tituted basically of the following component.

View solution

Q. Plasticity index is defined as the range of water content between

View solution

Q. The minimum depth of building foundations on

View solution

Q. The ratio of the undrained strength in the undrained state to the undrained strength, at the same water content, in the remoulded state, is called the sensivity of the clay. Its value for quick clays is

View solution

Q. The total weight of a pycnometer with water and oven dried soil 20 (g) is 1600 g. The pycnometer filled with water alone weighs 1500 g. The specific gravity of the soil, is

View solution

Q. The consolidation time for soils

View solution

Q. According to IS : 2720 - 1965, the composition of a dispersing solution used in pipette analysis for determining the size of particles, is

View solution

Q. Cohesive soils are generally

View solution

Q. If the coefficient of the active pressure Ka is 1/3, the coefficient of passive pressure Kp, is

View solution

Q. The inventor of the term soil mechanics, was

View solution

Q. Compression of soil occurs rapidly if voids are filled with

View solution

Q. A saturated soil sample has water content of 40% and specific gravity of soil particles 2.7. The void ratio of the soil, is

View solution

Q. For testing a saturated clay for shear strength, the test recommended, is

View solution

Q. The critical exist gradient of seepage water in soils, increases with

View solution

Q. If drainage is permitted throughout the test, during the application of both normal, and shear stresses so that full consolidation occurs and no excess pore pressure is set up at any stage of the test, is known as

View solution

Q. A soil sample of mass specific gravity 1.92, has a moisture content 30%. If the specific gravity of solids is 2.75, the degree of saturation, is

View solution

Q. For slopes of limited extent the surface of slippage, is usually along

View solution

Q. For a base failure of a slope, depth factor

View solution