Q. In the figure m(t) = 2 Sin2πt / t, s(t) = cos200πt, n(t) = sin199πt / t, the output y(t) will be

View solution

Q. In the following equation of M-ary PSK signal (where Ey is symbol energy), M becomes large. Then d will approach

View solution

Q. The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave is

View solution

Q. If k is dielectric constant of a medium, the velocity factor in that medium is

View solution

Q. Fourier series expansion of a real periodic signal with fundamental frequency is given by following equation. It is given that c₃ = 3 + j5. then c-₃ is

View solution

Q. A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) where g(t) is given by below equation. The resulting signal is then passes through an ideal low pass filter with bandwidth 1 kHz the output of the low pass filter would be

View solution

Q. If a signal voltage Vs is accompanied by a noise voltage Vn the signal to noise ratio is

View solution

Q. A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) where δ(n) is given below. The output at n = 4 is

View solution

Q. In a satellite transponder the power amplifier feeds power P to the transmitting antenna of gain G. If distance of earth is d, the power flux density is

View solution

Q. In a two stage cascade amplifier the equivalent noise temperatures are Te1 and Te2. If the gains of the two stages are G1 and G2, the overall noise temperature Te is

View solution

Q. A π matching network for coupling the transmitter output of the antenna is shown in figure.
In this C₂ should be tuned for

View solution

Q. In figure (A) and (B)

View solution

Q. For a three stage cascaded amplifier, having gains of G₁, G₂ and G₃ and noise figures of F₁, F₂, F₃ the overall noise figure

View solution

Q. Which of the following could be the equation for non-linear resistor shown in figure?

View solution

Q. Figure shows the arrangement of

View solution

Q. Noise figure is defined as

View solution

Q. If N is the number of binary digits needed to assign individual binary code designations to the M quantization levels, the signal to quantization noise ratio S0/Nq in PCM is

View solution

Q. If Vs is signal voltage, Vn is noise voltage, signal to noise ratio S/N is defined as

View solution

Q. The PDF of a Gaussian random variable X is given by following equation. The probability of the event {X = 4} is

View solution

Q. A single tone modulating signal Vm cos ωt modulates a carrier A cos ωct. The carrier power (modulated) and side band powers are respectively

View solution