Q. As compared to an ordinary semiconductor diode, a Schottky diode

View solution

Q. Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.
Reason (R): High reverse voltage causes Avalanche effect.

View solution

Q. As compared to an ordinary semiconductor diode, a Schottky diode

View solution

Q. At very high temperatures the extrinsic semi conductors become intrinsic because

View solution

Q. When a voltage is applied to a semiconductor crystal then the free electrons will flow.

View solution

Q. Ferrite have

View solution

Q. In a p type material the Fermi level is 0.3 eV above valence band. The concentration of acceptor atoms is increased. The new position of Fermi level is likely to be

View solution

Q. In an n-p-n transistor, the majority carriers in the base are

View solution

Q. An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is

View solution

Q. The number of doped regions in PIN diode is

View solution

Q. A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.

View solution

Q. In a bipolar transistor the barrier potential

View solution

Q. Crossover distortion behaviour is characteristic of

View solution

Q. If aac for transistor is 0.98 then βac is equal to

View solution

Q. Assertion (A): The conductivity of p type semiconductor is higher than that of intrinsic semiconductor.
Reason (R): The addition of donor impurity creates additional energy levels below conduction band.

View solution

Q. In an n-p-n transistor biased for operation in forward active region

View solution

Q. An increase in temperature increases the width of depletion layer.

View solution

Q. Calculate the stability factor and change in IC from 25°C to 100°C for, β = 50, RB/ RE = 250, ΔIC0 = 19.9 nA for emitter bias configuration.

View solution

Q. A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is

View solution

Q. Work function of oxide coated cathode is much lower than that of tungsten cathode.

View solution