Question
a.
42.53, 0.85 μA
b.
40.91, 0.58 μA
c.
40.91, 0.58 μA
d.
41.10, 0.39 μA
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Calculate the stability factor and change in IC from 25°C to 100°C for, β = 50, RB/ RE = 250, ΔIC0 = 19.9 nA for emitter bias configuration.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
View solution
Q. Work function of oxide coated cathode is much lower than that of tungsten cathode.
View solution
Q. The word enhancement mode is associated with
View solution
Q. In which region of a CE bipolar transistor is collector current almost constant?
View solution
Q. A zener diode is used in
View solution
Q. A particular green LED emits light of wavelength 5490, Å, the energy bandgap of the semiconductor material used there is .. h = 6.6 x 10-34 J sec.
View solution
Q. In a zener diode
View solution
Q. In a bipolar transistor which current is largest
View solution
Q. The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplification
View solution
Q. In p-n-p transistor the current IE has two components viz. IEP due to injection of holes from p-region to n-region and IE due to injection of electrons from n-region to p-region. Then
View solution
Q. In an n channel JFET, the gate is
View solution
Q. The amount of photoelectric emission current depends on
View solution
Q. Assertion (A): A p-n junction has high resistance in reverse direction.
Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.
View solution
Q. The drain characteristics of JFET in operating region, are
View solution
Q. As temperature increases
View solution
Q. When a reverse bias is applied to a p-n junction, the width of depletion layer.
View solution
Q. The Hall constant in Si bar is given by 5 x 103 cm³/ coulomb, the hole concentration in the bar is given by
View solution
Q. Which of the following devices has a silicon dioxide layer?
View solution
Q. For BJT transistor. The maximum power dissipation is specified as 350 mW if ambient temperature is 25°C. If ambient temperature is 60°C the maximum power dissipation should be limited to about
View solution
Q. The concentration of minority carriers in a semiconductor depends mainly on
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!