Q. Crossover distortion behaviour is characteristic of

View solution

Q. If aac for transistor is 0.98 then βac is equal to

View solution

Q. Assertion (A): The conductivity of p type semiconductor is higher than that of intrinsic semiconductor.
Reason (R): The addition of donor impurity creates additional energy levels below conduction band.

View solution

Q. In an n-p-n transistor biased for operation in forward active region

View solution

Q. An increase in temperature increases the width of depletion layer.

View solution

Q. Calculate the stability factor and change in IC from 25°C to 100°C for, β = 50, RB/ RE = 250, ΔIC0 = 19.9 nA for emitter bias configuration.

View solution

Q. A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is

View solution

Q. Work function of oxide coated cathode is much lower than that of tungsten cathode.

View solution

Q. The word enhancement mode is associated with

View solution

Q. In which region of a CE bipolar transistor is collector current almost constant?

View solution

Q. A zener diode is used in

View solution

Q. A particular green LED emits light of wavelength 5490, Å, the energy bandgap of the semiconductor material used there is .. h = 6.6 x 10-34 J sec.

View solution

Q. In a zener diode

View solution

Q. In a bipolar transistor which current is largest

View solution

Q. The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplification

View solution

Q. In p-n-p transistor the current IE has two components viz. IEP due to injection of holes from p-region to n-region and IE due to injection of electrons from n-region to p-region. Then

View solution

Q. In an n channel JFET, the gate is

View solution

Q. The amount of photoelectric emission current depends on

View solution

Q. Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

View solution

Q. The drain characteristics of JFET in operating region, are

View solution