Q. Measurement of Hall coefficient enables the determination of

View solution

Q. The process of deliberately adding impurity to a semi-conductor material is called

View solution

Q. If E is energy level of electron and EF is Fermi level, then

View solution

Q. The range of life time carriers (electrons and holes) is

View solution

Q. In the forward blocking region of a silicon, controlled rectifier, the SCR is

View solution

Q. Which of the following is a passive component?

View solution

Q. Greatest mobility can be expected in case of

View solution

Q. An enhancement mode MOSFET is off when the gate voltage is

View solution

Q. When atoms are held together by the sharing of valence electrons

View solution

Q. Thermal runaway is not possible in FET, because as the temperature of FET increases.

View solution

Q. Which of the following pairs of semiconductors and current carriers is correctly matched?

View solution

Q. The effect of a finite gain of operational amplifier used in an integrator is that

View solution

Q. The ripple factor from a capacitor filter __________ as the load resistance __________ .

View solution

Q. Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by

View solution

Q. Choose proper substitutes for x and y to make the following statement correct.
Tunnel diode, Avalanche photodiode are operated in x bias and y bias respectively.

View solution

Q. Assertion (A): When a zener diode breakdown, occurs the voltage across it is constant.

Reason (R): The upper limit of zener current is determined by power handling capacity.

View solution

Q. Consider the following statements

1. An iron cored choke is a nonlinear device.
2. A carbon resistor kept in a sunlight is a time - invariant and passive device.
3. A dry cell is a time - varying and active device.
4. An air capacitor is a time - invariant and passive device

Of these statements

View solution

Q. If 10 V is the peak voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit), then the maximum voltage on the reverse biased diode will be

View solution

Q. In energy band diagram of p type semiconductor the acceptor energy level is

View solution

Q. Given a power supply filter circuit, what measurements must be made of determine percentage regulation

View solution