Q. An enhancement mode MOSFET is off when the gate voltage is

View solution

Q. When atoms are held together by the sharing of valence electrons

View solution

Q. Thermal runaway is not possible in FET, because as the temperature of FET increases.

View solution

Q. Which of the following pairs of semiconductors and current carriers is correctly matched?

View solution

Q. The effect of a finite gain of operational amplifier used in an integrator is that

View solution

Q. The ripple factor from a capacitor filter __________ as the load resistance __________ .

View solution

Q. Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by

View solution

Q. Choose proper substitutes for x and y to make the following statement correct.
Tunnel diode, Avalanche photodiode are operated in x bias and y bias respectively.

View solution

Q. Assertion (A): When a zener diode breakdown, occurs the voltage across it is constant.

Reason (R): The upper limit of zener current is determined by power handling capacity.

View solution

Q. Consider the following statements

1. An iron cored choke is a nonlinear device.
2. A carbon resistor kept in a sunlight is a time - invariant and passive device.
3. A dry cell is a time - varying and active device.
4. An air capacitor is a time - invariant and passive device

Of these statements

View solution

Q. If 10 V is the peak voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit), then the maximum voltage on the reverse biased diode will be

View solution

Q. In energy band diagram of p type semiconductor the acceptor energy level is

View solution

Q. Given a power supply filter circuit, what measurements must be made of determine percentage regulation

View solution

Q. When the gate terminal of MOSFET is positive, it is said to operate in

View solution

Q. Assertion (A): In a Schottky diode the reverse recovery time is almost zero.

Reason (R): A Schottky diode has aluminium silicon junction.

View solution

Q. The drain characteristics of JFET are drawn between

View solution

Q. Electrical contact materials used in switches, brushes and relays must possess

View solution

Q. A JFET behaves as a constant current source when

View solution

Q. The electron and hole concentration in a intrinsic semiconductor are ni and Pi respectively when doped with a P type material, these change to n and P, respectively. Then

View solution

Q. The energy to cause thermionic emission is supplied by heating the cathode.

View solution