Question

In a JK Master slave flip flop

a.

both master and slave are positively clocked

b.

both master and slave are negatively clocked

c.

master is positively clocked and slave is negatively clocked

d.

master is negatively clocked and slave is positively clocked

Answer: (c).master is positively clocked and slave is negatively clocked

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a JK Master slave flip flop

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. A pulse train with a 1 MHz frequency is counted using a 1024 modulus ripple counter using JK flip flops. The maximum propagation delay for each flip-flop should be

Q. What will be maximum input that can be converted for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).

Q. If number of information bits is 11, the number of parity bits in Hamming code is

Q. The number of digit 1 present in the binary representation of 3 x 512 + 7 x 64 + 5 x 8 + 3 is

Q. A full adder adds

Q. For a Mod 64 parallel counter we need

Q. If the inputs to a 2 input XOR gate are high then, the output is high.

Q. The number of select lines in a 16 : 1 multiplexer are

Q. 9's complement of 56₁₀ is

Q. Which of the following characteristic are necessary for a sequential circuit?

1. It must have 6 gates
2. It must have feedback
3. Its output should depend on past value

Which of the above statements are correct?

Q. 1011₂ x 101₂ = __________ ₁₀

Q. A combination circuit is one in which the output depends on

Q. 71₈ = __________ .

Q. A parallel in-parallel out shift register can be used to introduce delay in digital circuits.

Q. Binary multiplication can be done by repeated addition.

Q. Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Q. The counter which require maximum number of FF for a given mod counter is

Q. The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

1. Program counter
2. Processor register
3. Certain status conditions

Select the correct answer using the codes given below :

Q. In a gate output is Low if and only if all inputs are High. The gate is

Q. With on-chip decoding, n address lines can access

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!