Question

With on-chip decoding, n address lines can access

a.

2n memory locations

b.

2n² memory locations

c.

2ⁿ memory locations

d.

n² memory location

Answer: (c).2ⁿ memory locations

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. With on-chip decoding, n address lines can access

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. A half adder can be used only for adding

Q. In the 8421 BCD code, the decimal number 125, is written as

Q. 110.11₂ x 110₂ = __________ ₁₀

Q. Y = A + A̅ B is the same as

Q. Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

Q. If an analog voltage is expressed in binary using 4 bits, each successive binary count would represent

Q. In a 4 input AND gate, the total number of High outputs for 16 input states are

Q. Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using

Q. The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be

Q. In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require

Q. A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,

Q. A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are

Q. Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Q. Hexadecimal number F is called to octal number

Q. A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are

Q. TTL logic is preferred to DRL logic because

Q. Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits

Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.

Q. A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is

Q. What do the contents of instruction register specify?

Q. In the decimal number 27, the digital 2 represents

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!