Q. For a Mod 64 parallel counter we need

View solution

Q. If the inputs to a 2 input XOR gate are high then, the output is high.

View solution

Q. The number of select lines in a 16 : 1 multiplexer are

View solution

Q. 9's complement of 56₁₀ is

View solution

Q. Which of the following characteristic are necessary for a sequential circuit?

1. It must have 6 gates
2. It must have feedback
3. Its output should depend on past value

Which of the above statements are correct?

View solution

Q. 1011₂ x 101₂ = __________ ₁₀

View solution

Q. A combination circuit is one in which the output depends on

View solution

Q. 71₈ = __________ .

View solution

Q. A parallel in-parallel out shift register can be used to introduce delay in digital circuits.

View solution

Q. Binary multiplication can be done by repeated addition.

View solution

Q. Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

View solution

Q. The counter which require maximum number of FF for a given mod counter is

View solution

Q. The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

1. Program counter
2. Processor register
3. Certain status conditions

Select the correct answer using the codes given below :

View solution

Q. In a gate output is Low if and only if all inputs are High. The gate is

View solution

Q. With on-chip decoding, n address lines can access

View solution

Q. A half adder can be used only for adding

View solution

Q. In the 8421 BCD code, the decimal number 125, is written as

View solution

Q. 110.11₂ x 110₂ = __________ ₁₀

View solution

Q. Y = A + A̅ B is the same as

View solution

Q. Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

View solution