Question
Reason (R): TTL gate with active pull up should not be used in wired AND connection.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R are correct but R is not correct explanation of A
c.
A is true, R is false
d.
A is false, R is true
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): In totem pole output the output impedance is low. Reason (R): TTL gate with active pull up should not be used in wired AND connection.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The counter which require maximum number of FF for a given mod counter is
View solution
Q. The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?
1. Program counter
2. Processor register
3. Certain status conditions
Select the correct answer using the codes given below :
View solution
Q. In a gate output is Low if and only if all inputs are High. The gate is
View solution
Q. With on-chip decoding, n address lines can access
View solution
Q. A half adder can be used only for adding
View solution
Q. In the 8421 BCD code, the decimal number 125, is written as
View solution
Q. 110.11₂ x 110₂ = __________ ₁₀
View solution
Q. Y = A + A̅ B is the same as
View solution
Q. Assertion (A): Different symbols are used for different gates
Reason (R): IEEE symbols are the same as traditional symbols for gates.
View solution
Q. If an analog voltage is expressed in binary using 4 bits, each successive binary count would represent
View solution
Q. In a 4 input AND gate, the total number of High outputs for 16 input states are
View solution
Q. Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
View solution
Q. The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be
View solution
Q. In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require
View solution
Q. A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
View solution
Q. A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
View solution
Q. Assertion (A): A demultiplexer cannot be used as a decoder
Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.
View solution
Q. Hexadecimal number F is called to octal number
View solution
Q. A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are
View solution
Q. TTL logic is preferred to DRL logic because
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
