Q. Which of the following circuits can be used as parallel-to-series converter?

View solution

Q. A digital clock uses __________ chip

View solution

Q. Which of the following conversion is incorrect?

View solution

Q. In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .

View solution

Q. TTL XOR gate is very suitable as LCO driver.

View solution

Q. A typical microcomputer has 65, 536 registers in its memory. It will be specified as

View solution

Q. A function table is required in very large numbers the memory most switched for this purpose would be

View solution

Q. What kind of signal does the times produce?

View solution

Q. Assertion (A): A presettable counter can be preset to any desired starting point

Reason (R): The maximum frequency of a ripple counter depends on the modulus.

View solution

Q. Which of the following is the least important consideration while selecting a logic technology?

View solution

Q. Is Schottky TTL, Schottky diode is used primary to

View solution

Q. What is the maximum output voltage from the 741 op-amp?

View solution

Q. A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires

View solution

Q. Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ACI 0 A4 H?

View solution

Q. If an inverter is placed at the input to an SR flip-flop, the result is

View solution

Q. RAM can be expanded to

View solution

Q. Large scale integration refers to

View solution

Q. Which of the following statements is not true in regard to storage time of a diode?

View solution

Q. Suppose a microprocessor has memory locations from 0000 to 3FFF, each storing I byte. How many bytes the memory can storing I bytes the memory can store?

View solution

Q. If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation

View solution