Question
a.
80-120
b.
200-300
c.
600-800
d.
1000-1100
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Regeneration of molecular seive requires it to be heated to a temperature of about __________ °C.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Steels with high carbon equivalent have poor weldability, because in these steels during welding
View solution
Q. If the pH value of a solution of sodium chloride is 7; then what will be the pH value of the solution after its electrolysis ?
View solution
Q. Measurement of the area of the indented surface is not involved in the __________ hardhes testing method.
View solution
Q. Salvage value is the most flexible criteria for analysing a financial investment. 'Salvaging' means
View solution
Q. Super conduction in metals is observed at a temperature of __________ °K.
View solution
Q. On-off control
View solution
Q. The tensile load-elongation curve of a metal does not describe
View solution
Q. Usual value of the resistance suitable for a wire resistance strain gauge is __________ ohms.
View solution
Q. Permanent set in a material is produced by subjecting it to
View solution
Q. The following is a typical anionic collector used in flotation.
View solution
Q. Which of the following test is used for distinguishing among dry oils, semi-drying oils and non drying oils ?
View solution
Q. The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
View solution
Q. The process of removal of scale formed during hot rolling of steel is termed as
View solution
Q. A psychrometer does not measure the __________ temperature of moist air.
View solution
Q. An ideal material for making cooking vessels should have
View solution
Q. The units of the rate constant for a second order reaction are
View solution
Q. The most serious manufacturing defect from fracture toughness point of view is
View solution
Q. Leakage in a cooking gas cylinder is detected by
View solution
Q. Which of the following is the most wear resistant grade of carbide used for the cutting tools?
View solution
Q. The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!