Q. The crushed material received for separation is called feed or

View solution

Q. For spheres, volume shape factor is given by

View solution

Q. Which of the following agitators having a large blade area, rotating at slow speed is used for mixing high viscosity liquids ( > 50000 centipoise) ?

View solution

Q. __________ is defined as the geometric mean of the relative rejections and the relative recoveries of two minerals.

View solution

Q. Maximum size reduction in a ball mill is done by the, __________ action.

View solution

Q. increasing the capacity of a screen __________ the screen effectiveness.

View solution

Q. The power number for a stirred tank becomes constant at high Reynolds number. In this limit, the variation of power input with impeller rotational speed (N) is proportional to

View solution

Q. Bond crushing law

View solution

Q. Flow of filtrate through the cake in a plate and frame filter press is best described by the __________ equation.

View solution

Q. Rittinger's number designates the new surface created per unit mechanical energy absorbed by the material being crushed. Larger value of Rittinger's number of a material indicates its

View solution

Q. Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater width of the discharge opening, cm)

View solution

Q. Vacuum is applied in __________ zone, in case of a general type continuous rotary drum vacuum filter.

View solution

Q. Which of the follwoing mechanical conveyors does not come under the division 'scrapers' ?

View solution

Q. Length/diameter ratio of a ball mill is

View solution

Q. Feed size of ≥ 25 cms can be accepted by

View solution

Q. Which is the most suitable conveyor for transportation of sticky material ?

View solution

Q. The most suitable equipment for removing the fine dust particle (< 1 micron dia.) from air below its dew point will be a/an

View solution

Q. Laminar flow region is said to exist during agitation of a liquid in an agitator, when the value of Reynolds number is

View solution

Q. Basic slag is not ground in

View solution

Q. Grindability of a material does not depend upon its

View solution