Q. Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater width of the discharge opening, cm)

View solution

Q. Vacuum is applied in __________ zone, in case of a general type continuous rotary drum vacuum filter.

View solution

Q. Which of the follwoing mechanical conveyors does not come under the division 'scrapers' ?

View solution

Q. Length/diameter ratio of a ball mill is

View solution

Q. Feed size of ≥ 25 cms can be accepted by

View solution

Q. Which is the most suitable conveyor for transportation of sticky material ?

View solution

Q. The most suitable equipment for removing the fine dust particle (< 1 micron dia.) from air below its dew point will be a/an

View solution

Q. Laminar flow region is said to exist during agitation of a liquid in an agitator, when the value of Reynolds number is

View solution

Q. Basic slag is not ground in

View solution

Q. Grindability of a material does not depend upon its

View solution

Q. Shape factor for a cylinder whose length equals its diameter is

View solution

Q. In case of a hammer crusher, the

View solution

Q. Dust laden air can be purified using a

View solution

Q. Energy consumed for crushing one ton of material ranges from __________ kWh.

View solution

Q. For transporting pasty material, one will use a/an

View solution

Q. Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a

View solution

Q. A tube mill compared to a ball mill

View solution

Q. Trommels separate a mixture of particles depending on their

View solution

Q. Size reduction does not occur due to compression in case of

View solution

Q. According to Taggart's rule for selecting between a gyratory crusher and a jaw crusher; the later should be used, if the hourly tonnage to be crushed divided by the square of the gape expressed in cm is less than

View solution