Question
a.
low carbon steel
b.
high carbon steel
c.
medium carbon steel
d.
high speed steel
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The ball bearings are, usually, made from
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The V-belt is used to transmit great amount of power and when the two pulleys are very near to each other.
View solution
Q. A coupling used to connect two perfectly aligned shafts, is
View solution
Q. According to I.B.R., the efficiency of a double riveted butt joint with double cover straps of equal width should be
View solution
Q. The buckling load will be maximum for a column, if
View solution
Q. The cap screws are
View solution
Q. In skew bevel gearing, the axes of shafts are
View solution
Q. A chain drive transmits __________ power as compared to belt drive.
View solution
Q. The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads.
View solution
Q. A triple riveted butt joint with double straps of unequal width is to be designed for a boiler shell. The pitch of the rivets in the outer row is double the pitch in the inner row and zig-zag riveting is proposed. Which of the following statement is correct?
View solution
Q. The form factor of a helical gear __________ with the increase in the helix angle.
View solution
Q. The taper on a rectangular sunk key is
View solution
Q. When carbon in the cast iron is in the form of cementite, the cast iron will be of white colour.
View solution
Q. A type of brake commonly used in motor cars is a
View solution
Q. In a nut and bolt, the diameter at which the ridges on the bolt are in complete touch with the ridges of the corresponding nut, is called pitch diameter.
View solution
Q. A double strap butt joint (with equal straps) is
View solution
Q. For a bevel gear having the pitch angle θ , the ratio of formative number of teeth (TE) to actual number of teeth (T) is
View solution
Q. The modulus of elasticity for mild steel is approximately equal to
View solution
Q. A connecting rod subjected to an axial load may buckle with
View solution
Q. When the lubricant is forced between the journal and the bearing by external pressure, the bearing is called hydrostatic lubricated bearing.
View solution
Q. Crushing resistance required to crush the rivet per pitch length is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!