Q. Assertion (A): Negative feedback reduces the gain of an amplifier

Reason (R): Negative feedback is very commonly used in amplifier circuits

View solution

Q. The emitter resistor RE in the emitter of CE amplifier stabilizes the dc operating point against variation in

View solution

Q. A radio frequency choke permits an easy flow of __________ current and at the same time it offers a very impedance to __________ currents.

View solution

Q. Assertion (A): In an op-amp the gain bandwidth product equals infinity

Reason (R): The change in open loop gain of an amplifier has almost no effect on closed loop gain

View solution

Q. Lower chip area requirements of MOS is advantage in

View solution

Q. For high frequency response of a transistor amplifier, suitable model to use is

View solution

Q. A transistor with α = 0.98 then β will be

View solution

Q. Harmonic distortion in CB amplifier may be least when the load resistance is

View solution

Q. If a common emitter amplifier with an emitter resistance RC has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be

View solution

Q. Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time)

View solution

Q. In amplifiers, the parasitic oscillation result due to

View solution

Q. A ripple in collector supply voltage of the output stage of amplifier causes noise.

View solution

Q. In a transistor IE = 10 mA, ICO = 0.5 μA and α = 0.995. Then ICEO =

View solution

Q. As a compared to a CB amplifier, a CE amplifier has

View solution

Q. The stray capacitance between the last stage and the first stage of an oscillator may cause

View solution

Q. In a voltage regulator circuit using zener diode the load voltage is nearly constant only if

View solution

Q. Negative feedback in amplifier

View solution

Q. Which of the following is the fastest switching device?

View solution

Q. Which of the following is not valid in case of bipolars?

View solution

Q. The input resistance of JFET ideally approaches

View solution