Q. Lower chip area requirements of MOS is advantage in

View solution

Q. For high frequency response of a transistor amplifier, suitable model to use is

View solution

Q. A transistor with α = 0.98 then β will be

View solution

Q. Harmonic distortion in CB amplifier may be least when the load resistance is

View solution

Q. If a common emitter amplifier with an emitter resistance RC has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be

View solution

Q. Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time)

View solution

Q. In amplifiers, the parasitic oscillation result due to

View solution

Q. A ripple in collector supply voltage of the output stage of amplifier causes noise.

View solution

Q. In a transistor IE = 10 mA, ICO = 0.5 μA and α = 0.995. Then ICEO =

View solution

Q. As a compared to a CB amplifier, a CE amplifier has

View solution

Q. The stray capacitance between the last stage and the first stage of an oscillator may cause

View solution

Q. In a voltage regulator circuit using zener diode the load voltage is nearly constant only if

View solution

Q. Negative feedback in amplifier

View solution

Q. Which of the following is the fastest switching device?

View solution

Q. Which of the following is not valid in case of bipolars?

View solution

Q. The input resistance of JFET ideally approaches

View solution

Q. In the analysis of common emitter amplifier we may neglect

View solution

Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is

View solution

Q. Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

View solution

Q. In CB amplifier the distortion of the input voltage waveform may occur due to

View solution