Question
a.
Kelvin network
b.
Lattice network
c.
Hybrid π
d.
T-network
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. For high frequency response of a transistor amplifier, suitable model to use is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A transistor with α = 0.98 then β will be
View solution
Q. Harmonic distortion in CB amplifier may be least when the load resistance is
View solution
Q. If a common emitter amplifier with an emitter resistance RC has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be
View solution
Q. Turn on time of a transistor switch is equal to sum of (where tr is rise time, td is delay time)
View solution
Q. In amplifiers, the parasitic oscillation result due to
View solution
Q. A ripple in collector supply voltage of the output stage of amplifier causes noise.
View solution
Q. In a transistor IE = 10 mA, ICO = 0.5 μA and α = 0.995. Then ICEO =
View solution
Q. As a compared to a CB amplifier, a CE amplifier has
View solution
Q. The stray capacitance between the last stage and the first stage of an oscillator may cause
View solution
Q. In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
View solution
Q. Negative feedback in amplifier
View solution
Q. Which of the following is the fastest switching device?
View solution
Q. Which of the following is not valid in case of bipolars?
View solution
Q. The input resistance of JFET ideally approaches
View solution
Q. In the analysis of common emitter amplifier we may neglect
View solution
Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is
View solution
Q. Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.
Reason (R): Hartley oscillator uses a tapped inductor
View solution
Q. In CB amplifier the distortion of the input voltage waveform may occur due to
View solution
Q. As compared to full wave rectifier, a half wave rectifier
View solution
Q. Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors
Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
