Question
1. applying anode voltage at a sufficient fast rate
2. applying sufficiently large anode voltage
3. increasing the temperature of SCR to a sufficiently
4. applying sufficiently large gate current
a.
1, 2, 4 only
b.
4 only
c.
1, 2, 3, 4
d.
none
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. SCR can be turned on by 1. applying anode voltage at a sufficient fast rate 2. applying sufficiently large anode voltage 3. increasing the temperature of SCR to a...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. When a diode is not conducting, its bias is
View solution
Q. The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
View solution
Q. The number of valence electrons in a donor atom is
View solution
Q. An electron rises through a voltage of 100 V. The energy acquired by it will be
View solution
Q. Measurement of hall coefficient enables the determination of
View solution
Q. Which of these has 3 layers?
View solution
Q. For an P-channel enhancement type MOSFET determine the drain current if K = 0.278 x 10¯³A/V², VGS = -4V, VT = -2V, Voltage equivalent at 27°C = 26 mV.
View solution
Q. The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately
View solution
Q. When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
View solution
Q. In which material do conduction and valence bands overlap
View solution
Q. For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in illumination results in
View solution
Q. The number of p-n junctions in a semiconductor diode are
View solution
Q. Assertion (A): A high junction temperature may destroy a diode.
Reason (R): As temperature increases the reverse saturation current increases.
View solution
Q. A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
View solution
Q. Assertion (A): In design of circuit using BJT, a derating factor is used.
Reason (R): As the ambient temperature increases, heat dissipation becomes slower.
View solution
Q. If the drift velocity of holes under a field gradient of 100 V/m is 5m/sec. Their mobility is
View solution
Q. In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹ᴼ/ cm³ the electron concentration is
View solution
Q. The behaviour of a JFET is similar to that of
View solution
Q. Dielectric strength of polythene is around
View solution
Q. Resistivity of hard drawn copper is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
