Question
a.
near absolute zero temperature
b.
near critical temperature
c.
at triple point
d.
under the conditions of high temperature and pressure
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Metals approach superconductivity conditions
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
View solution
Q. At absolute zero temperature a semiconductor behaves like
View solution
Q. In a 741 OP-amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to
View solution
Q. The current due to thermionic emission is given by Richardson Dushman equation.
View solution
Q. The thermionic emission current is given by
View solution
Q. In forward active region, the operation of a BJT
View solution
Q. The conductivity of a semiconductor crystal due to any current carrier is not proportional to
View solution
Q. A P-N junction diode dynamic conductance is directly proportional to
View solution
Q. Gold is often diffused into silicon P-N junction devices to
View solution
Q. In a solar cell, the photovoltaic voltages is the voltage at which the resultant current is
View solution
Q. The forbidden energy gap between the valence band and conduction band will be wide in case of
View solution
Q. At 0 K the forbidden energy gap in intrinsic semi conductor is about
View solution
Q. The resistance of a metallic wire would
View solution
Q. If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
View solution
Q. The O/P Power of a power amplifier is several times its input power. It is possible because
View solution
Q. In p type semiconductor holes are majority carriers.
View solution
Q. Due to the formation of Schottky defects the density of the crystal
View solution
Q. The band gap of silicon at 300K is
View solution
Q. Typical value of reverse current in a semiconductor diode is
View solution
Q. Which of the following element has four valence electrons?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!