Q. In a solar cell, the photovoltaic voltages is the voltage at which the resultant current is

View solution

Q. The forbidden energy gap between the valence band and conduction band will be wide in case of

View solution

Q. At 0 K the forbidden energy gap in intrinsic semi conductor is about

View solution

Q. The resistance of a metallic wire would

View solution

Q. If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is

View solution

Q. The O/P Power of a power amplifier is several times its input power. It is possible because

View solution

Q. In p type semiconductor holes are majority carriers.

View solution

Q. Due to the formation of Schottky defects the density of the crystal

View solution

Q. The band gap of silicon at 300K is

View solution

Q. Typical value of reverse current in a semiconductor diode is

View solution

Q. Which of the following element has four valence electrons?

View solution

Q. In a transistor operating in forward active mode

View solution

Q. In standard TTL, the 'totem pole' stage refers to

View solution

Q. In p type semiconductor, the hole concentration

View solution

Q. In order to achieve good stabilization in potential divider method current I1 through R1 and R2 should be

View solution

Q. A sample of N type semiconductor has electron density of 6.25 x 10⁸/cm² at 300 K. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density works out to be

View solution

Q. Addition of 0.3 to 3.5% silicon to iron

View solution

Q. A bistable multivibrator

View solution

Q. Transconductance indicates the

View solution

Q. The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to

View solution