Question
a.
zero signal IC and VBE
b.
zero signal IC and VCE
c.
zero signal IB and VCE
d.
zero signal IC, VCE
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Operating point signifies that
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For a junction FET in the pinch off region as the drain voltage is increased, the drain current
View solution
Q. For a MOS capacitor fabricated on a P-type semiconductor, strong inversion occurs when
View solution
Q. The primary function of a clamper circuit is to
View solution
Q. Breakdown in dielectric may be
View solution
Q. What is the function of silicon dioxide layer in MOSFETS?
View solution
Q. The modulation of effective base width by collector voltage is known as Early effect, hence reverse collector voltage
View solution
Q. Assertion (A): In intrinsic semiconductors, the charge concentration increases with temperature.
Reason (R): At higher temperatures, the forbidden energy gap in semiconductors is lower.
View solution
Q. Covalent bond energy in Germanium is approximately
View solution
Q. One electron volt is equivalent to
View solution
Q. Resistivity of electrical conductors is most affected by
View solution
Q. Wiedemann-Franz law correlates
View solution
Q. Holes and electrons move in opposite directions.
View solution
Q. AE 139 is a
View solution
Q. The function off an oxide layer in an IC device is to
1. mask against diffusion or ion implantation
2. insulate the surface electrically
3. increase the melting point of Si
4. produce a chemically stable protective layer
View solution
Q. The passage of current in an electrolyte is due to the movement of
View solution
Q. In a CE bipolar transistor operating in active region, collector current is independent of
View solution
Q. When a normal atom loses an electron
View solution
Q. A sample of N-type semiconductor has electron density of 6.25 x 10¹⁸/cm³ at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature the hole density works out to be
View solution
Q. Mobility is directly proportional to Hall coefficient.
View solution
Q. n channel FETs are better as compared to p-channel FET because
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!