Question

For a UJT if

R1 = Resistor from emitter to the base 1
R2 = Resistor from emitter to the base 2 and RBB = R1 + R2,

then the intrinsic stand off ratio (η) is

a.

A

b.

B

c.

C

d.

D

Answer: (d).D

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. For a UJT if R1 = Resistor from emitter to the base 1 R2 = Resistor from emitter to the base 2 and RBB = R1 + R2, then the intrinsic stand off ratio (η) is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The kinetic energy of free electrons in a metal is (where k is de-Broglie wave number of the electrons)

Q. Ripple factor is

Q. Figure represents a

Q. A p-n junction diode has

Q. Which of the following is true as regards photo emission?

Q. The power dissipation in a transistor is the product of

Q. The normal operation of JFET is

Q. The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is

Q. At room temperature the current in an intrinsic semiconductor is due to

Q. Work function is the maximum energy required by the fastest electron at 0 K to escape from the metal surface.

Q. The most commonly used semiconductor material is

Q. In which of these is reverse recovery time nearly zero?

Q. A transistor has a current gain of 0.99 in the CB mode. Its current gain in the CC mode is

Q. Secondary emission is always decremental.

Q. In a degenerate n type semiconductor material, the Fermi level,

Q. The types of carriers in a semiconductor are

Q. A potential of 7 V is applied to a silicon diode. A resistance of 1 K ohm is also in series with the diode. The current is

Q. Assertion (A): The reverse saturation current in a semiconductor diode is 4nA at 20°C and 32 nA at 50°C.
Reason (R): The reverse saturation current in a semiconductor diode doubles for every 10°C rise in temperature.

Q. Recombination produces new electron-hole pairs

Q. An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!