Q. Which of the following can be operated with positive as well as negative gate voltage?

View solution

Q. The reverse breakdown voltage of a diode depends on the extent of doping.

View solution

Q. The resistivity of a semiconductor

View solution

Q. The voltage at which Avalanche occurs is known as

View solution

Q. If the energy gap of a semiconductor is 1.1 eV, then it would be

View solution

Q. In intrinsic semiconductor the increase in conductivity per degree increase in temperature is about

View solution

Q. The ripple factor for a bridge rectifier is

View solution

Q. In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be

View solution

Q. Consider the following statements.
The functions of an oxide layer in an IC device is to

1. mask against diffusion or ion implant
2. insulate the surface electrically
3. increase the melting point of silicon
4. produce a chemically stable protective layer

Of these statements, which are true.

View solution

Q. The forbidden energy gap for germanium is

View solution

Q. If the gate of JFET is reverse biased, the width of depletion region

View solution

Q. A long specimen of P type semiconductor material

View solution

Q. For BJT, under saturation condition

View solution

Q. An inductor filter has a ripple that __________ with load resistance and consequently is used only with relatively __________ load currents.

View solution

Q. In a JFET

View solution

Q. Introducing a resistor in the emitter of a common amplifier stabilizes the d.c. operating point against variations in

View solution

Q. If the atomic number of germanium is 32, the number of electrons in the outer most shell will be

View solution

Q. Dielectric loss due to polarisation occurs in

View solution

Q. A metal loses electrons at room temperature.

View solution

Q. Consider the following statement associated with bipolar junction transistor and JFET

1. The former has higher input impedance than the later
2. The former has higher frequency stability than the later
3. The later has lower noise figure than the former
4. The later has higher power rating than the former

Of these statements

View solution